Advanced Sheet Metal Design Using NX CAD- Bracket Design Objective: The main objective of this project is to design a sheet metal BRACKET in NX cad sheet metal application workbench. Also, to perform the drafting for the bracket part. Software used: NX 12.0 To design and model the sheet metal casing in NX by using…

Report: Introduction: Draft Analysis is the process of assessing the designed plastic part if it has the drafting angles as per the requirement. In CATIA, draft analysis is done by the tool called Feature Draft Analysis. It shows the different draft angles available at different parts and says if it meets the requirement…

SWIZZ BEZEL CORE & CAVITY EXTRACTION: AIM: To design core &cavity extraction using part of swizz bezel.     FINDING MAIN TOOL DIRECTION: Already find the tooling axis on pervious section   ANALYSIS THE PART FOR CORE & CAVITY EXTRACTION: Checking a solid part using a command of FEATUR DRAFT ANALYSIS…

Aim: To develop the car Backdoor(Tail gate) with the reference of given skin data as perengineering standared by using catia v5  Back Door :The Back door is typically hinged, but sometimes attached by other mechanisms suchas tracks, in front of an opening which is used for entering and exiting a vehicle.A vehicle door…

AIM : To design the hood of a car with the given input Outer panel and its dimensions. Hood Introduction : The hood (North American English) or bonnet (Commonwealth English) is the hinged cover over the engine of motor vehicles. Hoods can open to allow access to the engine compartment or trunk (boot in Commonwealth English)…

CREATION OF BOSS AND DOGHOUSE FOR THE CNETER CONSOLE COIN HOLDER CONSIDERING THE DESIGN RULES IN CATIA   CREATION OF TOOLING AXIS: From visual inspection we can see that the tooling axis will be along the plane normal to the base of coin holder as we can see visually that hollow part of coin holder should fit either…