Bevel Gear Grid Dependency Test

The objective of this project is to perform a Grid Dependency Test on Bevel Gear to get optimum results using ANSYS Workbench

SI8 -PFI Engine Simulation

To simulate the entire SI8 - Port fuel injection engine using CONVERGE and to visualize; determine various engine parameters from the simulation results.

Simulation of a SI Engine

The objective of this project is to study the PFI Engine performance characteristics by setting up the spray modeling & combustion modeling in the CONVERGE studio and post-process the results in the Paraview and CYGWIN was used to run the commands for the simulation

Sunseeker Yacht Assembly

It is a 3D design model of luxury yacht which consists of several solid bodies and complex surfaces. This design is created using the SOLIDWORKS software. All the dimensions given is taken from the original product.

Preprocessing BMW M6

To surface mesh the BMW M6 model using different element size for different PIDs using ANSA v17.1.0 and observe the geometric change.

Design and CFD Analysis of a CPU fan

To validate a cfd code to perform a cfd flow analysis of a typical axial fan using sliding mesh method and to validate the results using affinity laws or fan laws.

CHT analysis

Conjugate heat transfer corresponds with the combination of heat transfer in solids and heat transfer in fluids. In solids, conduction often dominates whereas, in fluids, convection usually dominates.

HVAC Simulation using Ansys Fluent

1) Simulate the flow of a fluid through a Mixing Tee geometry.
2) Analyse the mixing effectiveness for different case setups.

American Chopper - Modelling in Solidworks

Create American chopper realistic rendering using SOLIDWORKS software. To practice and gain knowledge about using the tools in Solidworks to create a model.

Analysis on Plate with Hole/Holes

Perform a static analysis on two models of plate with holes. You will have to create the model in Solidworks and perform the analysis.

Meshing Of Turbocharger Using Ansa

To surface mesh and then conduct volumetric mesh for CFD application over the turbocharger model using different element size for different PIDs using ANSA v17.1.0 and observe the geometric change.

Design and Model a Turbofan

The objective of this project is to design, model and render a Turbofan Jet Engine using Solidworks and Solidworks Visualize 2018.

2D and 3D Meshing of an engine

The  objective is to create the 2D and 3D meshing for the given models