All Courses
All Courses
Courses by Software
Courses by Semester
Courses by Domain
Tool-focused Courses
Machine learning
POPULAR COURSES
Success Stories
OBJECTIVE To Comparison of results with base simulation and improved shell element properties under the given criteria by CASE 1-Run the base simulation without any modification to element properties. CASE 2-Run the base simulation with element properties. PROCEDURE CASE 1 First, create a new folder on the desktop.IN…
Akhilesh R
updated on 13 Nov 2021
OBJECTIVE
To Comparison of results with base simulation and improved shell element properties under the given criteria by
PROCEDURE
CASE 1
CASE 2
COMPARISION
CASE1 CASE 2
CONCLUTION
Thus the Comparison of results with base simulation and improved shell element properties under the given criteria. And compared the energy graph.
Leave a comment
Thanks for choosing to leave a comment. Please keep in mind that all the comments are moderated as per our comment policy, and your email will not be published for privacy reasons. Please leave a personal & meaningful conversation.
Other comments...
Assignment 6-Frontal Crash Simulation Challenge
Frontal Crash Simulation Challenge aim To Check the unit system and either follow[Mg mm s] or [Kg mm ms]. Create an appropriate interface, friction 0.2 and recommended parameters. Make sure of no penetrations and intersections. Correct rigid bodies if any issues. Create a rigid wall with friction 0.1. Compare the model…
29 Dec 2021 08:01 AM IST
Assignment 7-Side Pole Crash Simulation Challenge
Side Pole Crash Simulation Challenge AIM Check unit system and either follow [Mg mm s] or [Kg mm ms]. Create appropriate interface ,friction 0.2 and recommended parameters. Make sure of no penetration and intersections. Create…
29 Dec 2021 06:01 AM IST
Assignment 5-RADIOSS Interfaces & Study of Effect of Notches Challenge
AIM Create the mesh for bumper assembly,mesh size should be 6mm. Run the crash tube model as it is. Change the Inacti=6 and run. Create the type 11 contact and run. Remove both notches and remove boundary condition on rigid body node then run. Create a new notch in the middle,select the whole section and run Create…
29 Dec 2021 05:56 AM IST
Assignment 4-RADIOSS Material Laws Challenge
AIM: To run crash analysis on the given model by applying different materials laws available in Radioss and post-process the results Objective: To carry out simulations of the given starter files and compare the results. There shall be 7 cases (according to given parameters) and they are to be compared primarily via animations…
19 Nov 2021 07:27 AM IST
Related Courses
0 Hours of Content
Skill-Lync offers industry relevant advanced engineering courses for engineering students by partnering with industry experts.
© 2024 Skill-Lync Inc. All Rights Reserved.