Base Bracket Design

AIM :  To assemble the Butterfly Valve by using the sub parts created and apply the GD&T to the Butterfly Valve assembly drawing.   Introduction: Butterfly Valve: A butterfly valve is a valve that isolates or regulates the flow of a fluid. The closing mechanism is a disk that rotates. A butterfly valve…

AIM : Use the provided styling surface to come up with a back door design, use appropriate design methodologies, and provide the necessary reinforcements and embosses BACKDOOR : Back door/tailgate is a BiW component found in most of the cars,which provides access to the boot space.it could be hinged at top,side or split type according to the design of the particular vehicle.top hinged back doors will be supported with gas stays.

ROOF DESIGN CHALLENGE    AIM:                 To design a roof with all the components like front roof rail, rear roof rail, and bow roofs by following the given master sections and the high-quality surface, considering all the design requirements as per the OEM standards. ROOF  An automobile roof or car top is the portion…

FENDER DESIGN CHALLENGE AIM:               To design a  front fender of a car by following the given master section as per the design considerations of OEM. FENDER:                 Fender is a front side outer panel placed above front wheels of a car.its primary purpose is to prevent sand ,mud, rocks ,liquids and another…

AIM : To study on section modulus calculation and design a new hood with improved strength   SECTION MODULUS :                               Section modulus represents the strenght of a given component,higher the value higher its strength. it is the ratio of moment of inertia about neutral axis with distance from the outer…

AIM : Design Hood Outer Panel, Inner Panel and the necessary reinforcements by following the Master Section mentioned with the Design parameters explained in the videos.

WEEK 12 FINAL PROJECT  AIM : Creation of CAD model considering following inputs as like in OEM and tier1 companies   Opened seperate part workbench for each surfaces in the given input file and worked on each surfaces induvidually. SURFACE QUALITY INSPECTION :                                                            Surface…

WEEK 11 - A PILLAR DESIGN WITH MASTER SECTION  TOOLING AXIS CREATION :  Tooling axis is the direction in which mould travels. basically there are two pieces for mould,one cavity side and one possess projections of the component. the draft angle given for the component for ease of ejection, is drafted with reference to…

WEEK 10 CHALLENGE 3 : DOOR TRIM LOWER WITH ENGINEERING FEATURES AIM :  Create the Door Trim Lower Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft…

WEEK 10 CHALLENGE 2 ATTACHMENT FEATURE CREATION (DOG HOUSE)   DOG HOUSE :                       Dog house is an engineering feature used in plastic component designing. these are support features of a plastic component. dog houses are subjected to drafting…

OBJECTIVE : The objective of the project is to create a Bumper Plastic component through the given Class-A surface with tooling axis which meets the requirements of the draft angle and at the end perform the Draft analysis on the model.

The objective of this project is to Create the Switch Bezel Plastic component through the given Class-A surface with the tooling axis for the given Class-A Surface which should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model.

The objective of the project is to Create the Base Bracket Plastic component through the given Class-A surface with the tooling axis for the given Class-A Surface which should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model.

This project showcases my skill and experience working in CATIA Assembly workbench After modelling each components of the mechanism in the part workbench , it is assembled and constrained in the assembly workbench

ATTACHMENT  FEATURE CREATION (RIBS AND SCREW BOSSES)   : Both ribs and bosses are functional features in many plastic part designs. Ribs offer stability to side walls and standoffs such as bosses.