Creation of geometries by Coordinate system methods using AutoCad
Aim: Create the geometries from P1 to P2 using all the coordinates system methods and for P3, P4, P5, P6, P7, P8, P9, P10 use any one coordinate system and use the Line tool to create the geometries, Where required, use the circle tool. Introduction: AutoCAD was derived from a program that began in 197,…
NAGOTHI SRIDHANA SANTOSH KUMAR
updated on 01 Apr 2022
Project Details
Leave a comment
Thanks for choosing to leave a comment. Please keep in mind that all the comments are moderated as per our comment policy, and your email will not be published for privacy reasons. Please leave a personal & meaningful conversation.
Other comments...
Be the first to add a comment
Read more Projects by NAGOTHI SRIDHANA SANTOSH KUMAR (2)
Creating a Floor plan, Footing detail and Isometric view using AutoCad
Aim: To create a C.S of the load-bearing wall overspread footing using AutoCad. Step by Step Procedure: Open the AutoCAD application and Set up the units to the imperial template and the decimal system. Set up the limits in the command tab using LIM before drafting. Type the command "L" for the line and specify, Specify…
05 Apr 2022 08:58 AM IST
Creation of geometries by Coordinate system methods using AutoCad
Aim: Create the geometries from P1 to P2 using all the coordinates system methods and for P3, P4, P5, P6, P7, P8, P9, P10 use any one coordinate system and use the Line tool to create the geometries, Where required, use the circle tool. Introduction: AutoCAD was derived from a program that began in 197,…
01 Apr 2022 08:17 AM IST