Channel Flow Simulation using Converge CFD   Objective The objective of this project is to simulate a channel flow using Converge CFD for three different mesh sizes and compare the results between them. The different base mesh sizes are-   Case 1: dx=2e-4m,         dy=2e-4m,       …

Advanced CFD Meshing of the Turbocharger geometry using ANSA Objective The objective of this project is to clean the Turbocharger geometry and create a volumetric mesh using ANSA. Process The process is very straight forward as shown below- Topology clearing Surface Mesh generation Volumes creation Volumetric Mesh Topology…

Steady State Simulation of Flow over a Throttle Body Objective The objective of this project is to set up the steady state simulation for a flow over the throttle body when it is fully open. This simulation forms the first part, or a test run which will be followed by a Transient simulation. This will help to check the…

Transient Flow Simulation over the Throttle Body Objective The primary objective of this simulation is to calculate the end time of the flow and the throttle valve shall rotate about its axis as per the following given information-   From 0 to 2 milli secs, the throttle valve should rotate by 25 degrees. From 2 to…

Flow over a Backward-Facing Step (BSF) using Converge CFD   Objective The objective of this project is to simulate a Backward Facing Step using Converge CFD for three different mesh sizes and compare the results between them. The different base mesh sizes are-   Case 1: dx=2e-3m,        …